need help?

[storey999]

hi wot i need help with is ssspplug +huda for humax5400.
i have followed the step by step guide but it dosnt seem to work.
i have a humax5400 with boot loader 1.37 and 2.08(do i need to update this)
i have tryed changeing nullmodem leads still no joy.
the problem is when i open up ssspplug and click connect then monitor it says started but nothing else.
my settings for humax is
card-s-emu
ecm-emm
sssp
no auto nagra2
is there anything else i need to do with the box when i have hit connect ?
iam useing hot3.4 toh11.3
ihave updated pmc but not keys will this affect it?
plz help

[airliquide]

hi wot i need help with is ssspplug +huda for humax5400.
i have followed the step by step guide but it dosnt seem to work.
i have a humax5400 with boot loader 1.37 and 2.08(do i need to update this)
i have tryed changeing nullmodem leads still no joy.
the problem is when i open up ssspplug and click connect then monitor it says started but nothing else.
my settings for humax is
card-s-emu
ecm-emm
sssp
no auto nagra2
is there anything else i need to do with the box when i have hit connect ?
iam useing hot3.4 toh11.3
ihave updated pmc but not keys will this affect it?
plz help

Hi storey999... is not possible change bootloader From 1.37 To 2.08(humax is dead)here read post for cs for humax but nobody has the Humax.. and no see reply for question..no see nothing by others members,but this is not my problem,probably your problem is no good server or server down.. probably,i not use frequently humax 5400 for cs..receiver with rs232..pc .program for cs for me is not receiver for cs....yes important is also pmct,and (key.bin without dcw),here key.bin is for cs....no dcw at the moment.

[storey999]

hi i will try to update bootloader where do i get the file from?
i can connect with shamax but still no joy with ssspplug

[airliquide]

hi i will try to update bootloader where do i get the file from?
i can connect with shamax but still no joy with ssspplug

Hi storey999, this is my last reply, you probably no read , is not possible change bootloader from 1.37 To 2.08.....HUMAX DEAD.

[mogembo]

hi i will try to update bootloader where do i get the file from?
i can connect with shamax but still no joy with ssspplug
mate do not try to change humax system id and loader , it might kill your humax
if sharemax or ssplugin not working then check ur config. or server details
may be details is wrong or server down or change username password
for share max :HSIC and SSSPLUGIN :SSSP sharing protocol

[storey999]

i can load sharmax and loads ok and connects but i carnt connect to ssspplug any ideas

[mogembo]

make sure in sssplug correct com. and do not open any software while u running ssplug ( for example humax softloader or sharemax any software if it is belong to humax )
if still same then delete sssplug and install again

[storey999]

i have delete the sssp file and tryed it agen still no joy.is there a way that i can send the reciver to sumone to see if they can get it to work? at the mo iam only on bskyb till i get my dish set up will this make a diffrent?